UV DTF – C 037 Angels A4 gang sheet

UV DTF – 037 Angels A4 gang sheet

How to Apply Your UVDTF Decal

1. Get the Surface Ready
Make sure the spot you’re sticking your decal on is clean, dry, and at room temperature. A quick wipe-down to remove any dust, grease, or fingerprints will help it stick much better.

2. Stick It On

• Gently peel the clear sheet (A) away from the backing (B) — your design will stay on the clear sheet.

• Line it up exactly where you want it.

• Start pressing it down from the middle and work your way out to the edges to help prevent bubbles.

3. Smooth Out Bubbles

• Use your fingers (or a soft squeegee/credit card) to press firmly from the center outward, pushing out any little air pockets.

• Try to use even pressure so the whole design sticks properly.

• Be gentle to avoid scratching the design or damaging the surface.

4. Peel Off the Clear Layer

• Once it’s fully stuck down, slowly peel off the clear film at a low angle.

• Check as you go — if any part starts to lift, press it back down and continue peeling.

✨ Pro Tips for Best Results

• Best Surfaces: Smooth, hard, non-porous surfaces like glass, metal, plastic, or coated wood work best.

• Avoid Curves: Flat areas are ideal — decals may wrinkle or lift on heavily curved surfaces.

• Temperature Matters: Try to apply indoors at room temperature. Extreme cold or heat can affect adhesion.

• No Rubbing Alcohol Needed: A simple wipe with a dry or slightly damp cloth is enough — strong cleaners can reduce stickiness.

• Let It Cure: Once applied, let your decal rest for 24 hours before washing or handling to make sure it’s fully bonded.

• Handle With Care: These decals are durable, but gentle hand-washing (if on drinkware) will help them last longer.