GIFT CARD bauble – controller

approx 20x8cm. Each bauble is made up of 3 main pieces. The back and 1 inner pieces are to be glued and painted. The front does not get glued on. The hanging ribbon will hold it together (not supplied) and enable you to open the bauble to put a gift card inside. The 2 straight edge holes are used to thread ribbon and tie together once finished to stop the contents falling out and it is then ready to be gifted.

Etched 5cm tags to hang from the ribbon can be purchased (max 40 characters). Plain tags are listed in 10 packs seperatly if you prefer to write your own.