4 piece Plaque stand for craft fairs

This plaque/sign stand is 20x30cm and stands at 18cm tall. It can hold 10 plaques/signs with 16mm gap for them to stand. Thinner plaques can flip to see the items behind, thicker items wouldn’t tilt as much. The stand starts low and goes higher to the back to enable you to maximise space on your table and so that you can see the full plaque whne pulling the ones infront forward. There are two width styles now available, a narrower stand that holds 10cm coasters, this can also hold items larger, even 30cm wide, but the wider base gives better stability for items over 20cm wide. The large stand holds the 40cm road signs easily as shown in the photo. The round plaque at the front is 20cm and sits really well. This is made in 4 pieces that slot together so super quick and easy to set up. It is cut from moisture resistant 6mm MDF so really sturdy and suitable for painting. If painting and the joints are tight, simply sand the joint a little until you get the desired fit.